Professional Treatment Guide

Vacuslim 48 is a professional body contouring treatment designed to reduce fat, minimise cellulite, and support lymphatic drainage through a unique vacuum-sealed, hot-cold therapy system. This guide provides step-by-step instructions for performing Vacuslim 48 treatments on different areas of the body, including full-body and arm-focused sessions. Whether you're new to Vacuslim 48 or looking to refine your technique, follow this protocol to ensure safe, effective, and consistent results for your clients.

Full-Body Treatment

  • Step 1: Initial Measurements

    Record the client's weight and body measurements (in inches or cm) at specific points. Mark these locations and note them down for later comparison.

  • Step 2: Apply Serum & Cream

    Have the client standing. Put on protective gloves and apply the Vacuslim 48 Thermo Slimming Serum (1) from knees up to the upper abdomen (below the chest). Follow with Vacuslim 48 Slimming & Firming Cream (2), gently massaging to spread the cryogenic, cooling effect.

  • Step 3: Fit the Vacuum Bag

    Slide the Vacuslim 48 bag over the body, closing the top under the chest with an elastic band, and tightening the lower part to prevent air intake. Ensure legs and feet remain straight. For wider waists, use two velcro straps—avoid overtightening. Position the bag ~5–7 cm below the navel.

  • Step 4: Create Vacuum & Wait

    Insert the handheld vacuum extension tube at the bag’s base, evacuate all air to generate the vacuum seal. Leave the client resting (lying or seated) for 30 minutes to allow full absorption and metabolite activation.

  • Step 5: Finish & Measure

    Remove the bag and towel away any excess fluid. Apply Vacuslim 48 Anti‑Cellulite & Firming Oil (3) and perform a brief 5-minute massage. Re-measure weight and the same body points marked earlier to assess progress.

Shop Products

Arm Treatment (Hand Set)

  • Step 1: Prep & Apply Products

    Measure and mark the upper arm (between elbow and shoulder). Apply Serum (1), followed by Cream (2) on the upper arm, massaging gently—no deep rubbing needed.

  • Step 2: Bag Setup

    Wrap one Vacuslim 48 “Hand Bag” around the upper arm. Close the top lightly with an elastic band—tightening isn't necessary. Secure the bottom with a cable tie and vacuum out the air to form a vacuum seal.

  • Step 3: Timed Release

    After 3 minutes, remove the upper elastic band (this activates the active ingredients while minimizing discomfort), keeping the vacuum bag in place for up to 30 minutes.

  • Step 4: Massage & Measure

    Remove the bag and perform a short massage with Anti‑Cellulite & Firming Oil (3). Re-measure arm circumference at the marked points to track reduction.
Shop Products

Recommended Protocol

  • Treatments are best scheduled every other day, for a total of 6–12 sessions (or until the desired outcome is achieved).
  • Encourage clients to continue at-home use of Serum 1 (roll-on) and Cream 2 between sessions to maintain results.